Operating the Code Alarm CPL100 Keyless Entry Upgrade

Operating the Code Alarm CPL100 Keyless Entry Upgrade

System Functions

Arming the Security System: To arm the system, exit the vehicle, close all doors, then press the LOCK button on your keyless entry remote control. The system will flash the parking lights 2 times, indicating the system is armed, and activated the starter disable feature. The status indicator (red warning light) will blink steadily, once per second.

Pre-arm Mode: If the system sounds 1 time and the parking lights flash only 1 time, this indicates that the vehicle’s interior light is on or an entrance is left open. Check to see that all doors hood and trunk are closed properly. Once all entrances are secured (and the interior light is off), this system will sound/flash again. The system is now fully armed. (If the entrance is not secured within 4 minutes, the system will arm and ignore the unsecured entrance until it is closed.)

Disarming the Security System: To disarm the system press the UNLOCK button. The system will flash the parking lights 1 time.

To engage valet mode:

1. Turn the ignition key ON/OFF, ON/OFF, ON/OFF.
2. The red LED will flash 2 times quickly then pause indicating that the system is in valet mode. When valet mode is activated all security functions will be disabled.

To disengage valet mode:

1. Turn the ignition key ON/OFF, ON/OFF, ON/OFF.
2. The red LED will turn off indicating that the system has exited valet mode.

When Your Security System is Triggered: The CPL Security System will trigger if one of the following events occurs while the system is armed:

• Any protected entrance is opened.
• The vehicle ignition is turned on.
• The vehicle is jolted hard enough to signal the impact sensor.

Once the alarm is triggered, the horn will sound and the vehicles parking lights will flash for 30 seconds. The system will then re-arm, awaiting the next intrusion attempt.

Attempted Intrusion Identification: Pressing UNLOCK after a full 30 second trigger cycle has completed, the horn will honk 4 times and the LED will flash a number of times to indicate which input triggered the alarm. Turning on the ignition or pressing the valet/override button will reset the LED flashes, pressing the valet/override button will also honk the horn to match the LED flashes before it resets. Number of flashes: 1 = Interior Theft Sensor (Shock Sensor). 2 = Door Input. 4 = Hood/Trunk input. 5 = Ignition.

Emergency Disarm Procedure: If your remote control is lost or fails to function, use this procedure to disarm the CPL Security System and start your vehicle.

1. Use the keys to enter the vehicle. The alarm will sound once the door is opened.
2. Insert the key into the ignition and turn to the ON position.
3. Locate and press the emergency override button. The alarm will turn off and then you will be able to start the vehicle.