Operating the Code Alarm PC7400 or ELITE7400 Remote Start Security System

Operating the Code Alarm PC7400 or ELITE7400 Remote Start Security System

Using Your Remote Transmitter

Locking the Vehicle Doors: To lock the doors, exit the vehicle, close all doors, then press the LOCK button. The status indicator (red warning light on the dash) will blink steadily, once per second, if equipped.

Unlocking the Vehicle Doors: To unlock the vehicle, press the UNLOCK button. The horn will “honk” and the parking lights will flash once, and the doors will unlock. The courtesy light will turn on for 1 minute, or until the vehicle is started.

Two-Stage Door Unlock: If this feature is enabled on your system, pressing UNLOCK one time will unlock only the driver’s door. Press UNLOCK again within 1 minute to unlock all doors.

Activating the Trunk Release Feature: Press and hold TRUNK to open the vehicle trunk or hatch (if equipped and connected). If this button is used to operate another accessory, the accessory will stay active for as long as the button is held.

Turning on the Vehicle Headlights: Press and hold the LOCK button to turn on the vehicle headlights. The lights will stay on for 20 seconds, or until LIGHTS is pressed again.

Using the Progressive Car Finder Feature: Press FIND on the remote control to locate your vehicle. The horn will emit five short “honks” at low volume, increasing in volume each of three times the button is pressed.

Personal Protection Alarm (Panic): Press and hold the PANIC button to activate the vehicle horn and parking lights for 30 seconds. (If the vehicle horn is connected, the horn will “honk” for 30 seconds.) Press any remote control button to turn off the Panic alarm.

Remote Start / Stop Feature: Press LOCK, then press START within 2 seconds on the remote control. If all safety parameters are correct, the engine will start within 5 seconds (diesel engines will take longer.) Press and hold START again to turn off the vehicle.

Using Second Car Mode: If this feature is enabled, one transmitter will control two vehicles equipped with a Power Code system. To operate the second vehicle, press the shift button, then within two seconds, press the desired function button.

Using Your Remote Starter

Starting Your Vehicle: The remote start function is activated by pressing the ARM button, then pressing the START button on the remote control within 2 seconds. The system will check the vehicle to ensure that it is safe to start, and if all safety parameters are correct, the engine will start within 5 seconds (diesel engines will take longer.) Press and hold START again to turn off the vehicle.

If your vehicle stalls or does not start: If the vehicle stalls or does not start, the Power Code PC 7400 will pause 5 seconds, then try 3 more times to start the vehicle (a total of four attempts). The system pauses 5 seconds between each start attempt. If the vehicle does not start after the fourth attempt, the Power Code PC 7400 will abort the start process.

Your vehicle can be started by remote