Programming Features on the Code Alarm PRO F60 Alarm System

Programming Features on the Code Alarm PROF60 / F60 Alarm System

Programming a Transmitter/Adding Remotes to Your System

The PROF60 / F60 has the ability to operate from up to eight (8) remote controls. Follow these instructions to add a remote control to your system.

1. Make sure the system is disarmed and the ignition is off.
2. Open the driver's door.
3. Turn vehicle ignition on.
4. Press and hold emergency override button. After 15 seconds, the horn will sound three (3) times. This indicates that the unit has entered the remote control programming mode.
5. Release the button.
6. Press the ARM button (button 1) on the remote control to be programmed. The horn will sound once, indicating that the system has "learned" that remote control.
7. Repeat step 6 for any additional remote controls.
8. Turn the vehicle ignition off to exit the programming mode. Test all remote controls to ensure that they work properly.

Programming Selectable Options

Note: Transmitters must be programmed prior to these steps.

1. Repeat steps 1-4 of Adding Remote Controls to your System (above).
2. Press and release the emergency override button. The horn will sound four (4) times. This indicates that the unit has entered the Keyless Options Programming mode.
3. Press the Find/Panic button to advance to the next feature. The horn will sound a number of times to indicate the number of the option.
4. Press the Arm button to turn the option on or all. The vehicle status indicator on the dashboard indicates whether an option is on or off. If the selected option is ON, the indicator will light. If the selected option is OFF, the indicator will turn off. The status indicator will turn on or 011 when an option is changed.
5. When changes are complete, press and release the emergency override button to continue to the next option bank. (Horn will sound five (5) times.)
6. To reset all options back to factory defaults, press the Unlock/Disarm button. Note: Option Bank four (4) Installer Options will never reset.
7. Turn ignition off to exit programming. See Options Chart below.

Adjusting the Onboard IT-s Interior Theft Sensor

The IT-s is factory pre-set at a moderate sensitivity level and has two adjustment points: Lite-Touch and Full Shock.

Adjusting Lite-Touch Sensitivity:

1. To program the sensitivity of the lite touch trigger, simply enter into the installer options bank, then advance to the Lite Touch Adjustment. Once in the Lite Touch Adjustment option, use the ARM button of the transmitter to increase, and the DISARM button to decrease the sensitivity.
2. To verify the sensitivity, strike the vehicle (while in programming) with the amount of force you feel is acceptable for a lite touch trigger. If the system chirps, it will recognize that force; otherwise increase or decrease to obtain proper sensitivity.

Adjusting Full-Shock Sensitivity:

1. To program the sensitivity of the full trigger simply enter into the installer options bank