Remote Operation for the Code Alarm CA210 Keyless Entry System

Remote Operation for the Code Alarm CA210 Keyless Entry System 

Your System has many features and available options some of which are selected at time of installation. Consult your installing dealer for options that may have been installed and are not listed.

LOCKING THE SYSTEM:

1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.
2. Press and release the LOCK button of your key chain transmitter one time. The vehicle's doors will lock, the parking lights will flash once, the horn will honk once, and the dash mounted LED will begin to flash slowly confirming the system is locked. If the optional starter inhibit feature is installed, the starter inhibit feature will turn on.

SILENT LOCKING:

1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.
2. Press and hold both LOCK & UNLOCK buttons of your key chain transmitter for 2 seconds. The parking lights will flash once, and the dash mounted LED will begin to flash slowly confirming the system is locked. The horn will not honk. If the optional starter inhibit feature is installed, it will activate.

UNLOCKING THE SYSTEM: As you approach the vehicle, press and release the UNLOCK button on the keychain transmitter. The vehicle's doors will unlock, the parking lights will flash 2 times, the horn will honk 2 times, and the dash mounted LED will turn off. If the optional starter inhibit feature is installed, the starter inhibit feature will turn off.

SILENT UNLOCKING: As you approach the vehicle, press and hold both LOCK & UNLOCK buttons on your key-chain transmitter for 2 seconds. The parking lights will flash 2 times, and the dash mounted LED will turn off confirming that the system is unlocked. The horn will not honk. If the optional starter inhibit feature is installed, it will deactivate.

VALET SWITCH: The valet switch allows you to temporarily bypass the optional starter inhibit feature, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, the optional starter inhibit feature is bypassed, however the remote panic feature and remote door locks will remain operational.

1. Enter the vehicle, and turn the ignition key to the ON position.
2. Press and hold the valet pushbutton switch until the dash mounted LED turns on solid. The system will remain in the valet mode.
3. To return to normal operation, press and release the push button switch any time the ignition is on.

NOTE: Always remember to return the vehicle to the valet OFF position. This will ensure that the vehicle remains protected at all times.

USING THE VALET SWITCH/ MANUAL OVERRIDE: Your system can be disarmed without the use of the keychain transmitter. This is necessary, since you will need the ability to operate your vehicle if the transmitter is lost or its battery fails. Typically this override mode is used only if the transmitter has become inoperative. To by-pass the alarm system:

1. Open the vehicle door.
2. Turn the ignition key to the ON position.
3. Within 5 seconds, press and release the valet pushbutton switch. The optional starter inhibit feature will enter the (by-passed) mode. You c