Information, Programming Guide and Support for the Code Alarm DIYTX Transmitter

Information on the Code Alarm DIYTX Transmitter
	DIYTX Programming Guide
Compatible With:
This Transmitter has been Discontinued and therefore replaced with:
Required Batteries: CR2025 (2)
Programming Instructions: To program transmitters: Enter the vehicle, and turn the ignition switch to the ON position. Press and release the Programming button switch 3 times. Press and hold the LOCK button of the transmitter you wish to program. The lights will flash 1 time, indicating that the system is accepting the programming of channel #1 which is lock. "Repeat step 3 for each transmitter you wish to program" Press and release the valet push button switch 1 time to advance to channel 2. Press and hold the UNLOCK button of the transmitter you wish to program. The lights will flash 1 time, indicating that the system is accepting the programming of channel #2 which is unlock. "Repeat step 6 for each transmitter you wish to program" Press and release the valet push button switch 1 time to advance to channel 3. Press and hold the TRUNK button of the transmitter you wish to program. The lights will flash 1 time, indicating that the system is accepting the programming of channel #3 which is trunk. "Repeat step 9 for each transmitter you wish to program" Press and release the valet push button switch 1 time to advance to channel 4. Press and hold the STAR button of the transmitter you wish to program. The lights will flash 1 time, indicating that the system is accepting the programming of channel #4 which is remote start. "Repeat step 12 for each transmitter you wish to program".