Wired Headphones: There are two 1/8” headphone jacks on the VOH681 or VOH681P that can be used with any standard stereo headphones. These jacks are controlled by the volume up / down buttons on the VOH681 or VOH681P or the remote control. Remove and save the protective plastic cover to access the jacks. Remember to replace the cover when the jacks are not in use.
Wireless Headphones: The VOH681 or VOH681P includes a built in infrared transmitter for use with Audiovox wireless headphones (PN MVSWHS). Turning the headphone switch on, and wearing them activates the internal micro switch which will activate the internal IR receiver and the volume can then be adjusted separately with the controls on each headset. Any number of wireless headphones can be used, but all must be within a line of sight from the transmitter, as infrared transmissions, like visible light travel only in a straight line. See the documentation accompanying your External Audiovox wireless headphones.
Wired FM Modulator: Your video system may be equipped with an RF modulator, that allows you to listen to the VOH681 or VOH681P’s audio signal by tuning your vehicle’s radio to the selected frequency, (88.7 or 89.1 - Check with your installer) and turning on the remote mounted RF modulator switch. (In most cases this toggle switch will be located underneath the driver’s side of the dash, check with your installer for the exact location.) Whenever the RF modulator is on, broadcast radio reception will be poor. Turning the remote mounted toggle switch off will allow normal radio reception.
Video Output: The VOH681 or VOH681P provides a video output for an optional video monitor(s). (Refer to page 7 of the installation guide for more details.) This output will provide a video signal that duplicates the signal displayed by the VOH681 or VOH681P to an additional monitor or video display. Please see your installer for more information.
Audiovox Video Cassette Player (AV1): In most installations a VCP will be connected to the “AV1” input. To view a video cassette, turn the VOH681 or VOH681P On and press the source button on its control pad until the “AV1” indicator LED illuminates. The VCP may also be operated with a remote or the buttons on its face. The VOH681 orVOH681P is now ready to play the audio and video signals from the VCP if it is connected to the “AV1” input. Inserting a tape into the VCP will automatically turn it on and activate the play mode. If a rewound tape had already been loaded into the VCP, prior to its activation, press play on the VCP or on the remote control to view the tape. For more information see the operator’s manual accompanying your VCP.
AV2: The second video input may be connected to a DVD player, video game system, or other audio / video input. To play the AV2 source, turn the VOH681 or VOH681P on and press the source button on the pod until the “AV2” indicator LED illuminates. Turn the source component on with its power button or remote control. The VOH681 or VOH681P is now ready to play the audio and video signals from the source connected to AV2 inputs.