Operating Instructions for the Code Alarm CA2050 Keyless Entry Transmitter

Operation of the Code Alarm CA2050 Keyless Entry Remote Transmitter
Locking the Vehicle	Exit the vehicle and close all doors.  Press the Lock button. The parking lights will flash 2 times, indicating the system has locked the doors and activated the starter interrupt feature (if equipped and connected). The LED status indicator will blink steadily, once per second. Note: The system is defaulted with Silent Choice enabled, which requires a second press of the button to activate an audible arming response from the vehicle.
Unlocking the Vehicle	Press the Unlock button. The parking lights will flash 1 time, indicating the system has unlocked the doors and disabled the starter interrupt feature (if equipped and connected). Note: The system is defaulted with Silent Choice enabled, which requires a second press of the button to activate an audible arming response from the vehicle.
Valet Mode	To engage valet mode: Turn the ignition key to the ON position. Press and hold the emergency override button. The LED will light solid indicating that the system is in valet mode. When valet mode is activated the status LED will light solid, and the starter interrupt feature will be disabled. To disengage valet mode: Turn the ignition key to the ON position. Press and release the emergency override button. The LED will turn off indicating that the system has exited valet mode.
Activating the Trunk Release Feature (Optional)	If this feature is enabled on your system, pressing and holding the Trunk button for 3 seconds will open the vehicle’s trunk or hatch.
Using the Progressive Car Finder Feature	Press the Find/Alert button to locate your vehicle. The system will sound 5 times at low volume, increasing in volume each time the button is pressed.
Using the Personal Protection Alarm (Panic)	Press and hold the Alert button for 3 seconds to activate the personal protection alarm. During panic mode, the normal function of the transmitter buttons will be suspended. The transmitter’s and buttons can be used to lock and unlock the door (if the option is installed). To stop the alarm, press and hold the button on the transmitter again for 3 seconds. The system will automatically stop after 30 seconds.
Replace Remote Batteries	1-Way 4 Button Remote Control: The batteries (model CR2016) inside each remote control should last approximately 1 year under normal use. When the batteries become weak you will notice the remote control range (the distance from the vehicle the remote control will work) deteriorate and the small LED on the remote control will dim. To replace the remote control batteries: Remove 3 screws and disassemble the halves of the remote control. Remove