Using FIND on the Jensen NVX430BT GPS Navigation System
One of the most frequently used functions of The NVX430BT Navigator is selecting the destination. Once you have the destination, you can start navigating. Getting to this point should be as fast as possible. The NVX430BT Navigator provides you with a versatile search engine designed to find your chosen destination after only a few taps on the screen.
Note: If you select a location in any part of the Find system, you will normally drop back to the map screen, where you will have several possible actions (set as start, set as destination, add as via, continue route with, mark with a pin, or add as a POI item). However, if you enter the Find system using the Find & GO button, The NVX430BT Navigator will immediately put you into Cockpit mode and start navigation.
Find & GO (Main menu)
As just mentioned, the fastest way to find your destination and start navigating is to tap Find & GO in the Main Menu (4.1). This will put you on the Find screen, and as soon as you pick a destination, The NVX430BT Navigator will immediately show the Cockpit screen and start navigation. This means that if you plan your route to one of your Favorite destinations, you only need two taps to start navigating.
Selection by tapping the map
It is also very easy to set your destination using the map. Just browse to your desired destination on the map, tap it, and the Cursor menu with the possible actions will then open automatically.
Note: When appearing automatically, the Cursor menu remains open for a few seconds only. If you decide not to choose any of the actions listed, the menu closes automatically. When you open it manually, it will remain until you close it or switch to another screen.
Tip: If you want the selected point shown in the center of the map, close and reopen the menu or wait until it closes and open it again. By opening the Cursor menu manually, the map will be moved to have the selected location in the center.
Using the Find menu
The Find menu is accessible by the Find & GO button at the Main menu (4.1) or by the Menu buttons of the map screens (4.5.7). The Find menu gives you various possibilities for selecting a location.
Find an Address, Street, Intersection or City
Searching for a city, a street, an intersection, or an exact address can all be done in the Find Address module? If you know at least a part of the address, this is the quickest way to find the location.
The following illustration shows the structure of the address-search module. There are five levels (Country, State, City, Street and Address). The state level appears
only in case of some countries (e.g. Australia, USA). The list of recent cities and states is the entry point of the module. The green rectangles are the exits. You can complete your search by selecting the center of a settlement, the midpoint of a street, an intersection of two roads, or an exact address.
You enter the module at Level 3. From this point you can go forward (down) to give the name of the street, then the house number or intersection, or backward (up) to change the city, state or country to search.
There are 10 more pages in the manual addressing in detail how to use the Find feature.
Please access the <a style="CO