Installing the Audiovox CMOS1 Camera

Installing the Audiovox CMOS1 Camera 

Installation

Installation 1:

1. Locate suitable mounting location at rear of vehicle.

2. Use the camera mounting bracket as a template to mark the mounting hole locations.

3. Drill two 3/16 inch holes.

4. Attach the camera-mounting bracket to the vehicle with the lens shroud on topside. If lens shroud is on the bottom, then the camera must be removed from the bracket and turned 180 degrees and then reattached to the bracket.

5. The camera cable can be routed through an existing grommet or use a location where a 11/16 inch hole can be drilled. Be sure to check behind intended drilling location. Check for interference with license plate lights, hatch release switch and/or mechanism. If not using an existing factory grommet, drill a 11/16 inch hole at the selected location. Coat edge of hole with rust preventative. Route the camera cable connector through the hole and insert grommet into hole.

6. The camera cable to the extension cable connect as described below:

A. Yellow RCA- connect to Video (Camera Yellow RCA)

B. White RCA- connect to audio (Camera White RCA)

C. Camera red wire- connect to reverse lamp 12V voltage

D. Camera black wire- connect to chassis ground

7. The extension cable other head connected to the monitor. Yellow RCA connected to the Video input,White RCA connected to the Audio input.

Camera Installation 2 (Viewing angle does not adjust)

1. Locate suitable mounting location at rear of vehicle.

2. Use the supplied mounting template to mark the mounting hole locations.

3. Drill two 3/16 inch holes for mounting.

4. Use screws provided to attach the camera backboard to the vehicle with the lens shroud on topside.

5. The camera cable can be routed through an existing grommet or use a location where a 11/16 inch hole can be drilled. Be sure to check behind intended drilling location. Check for interference with license plate lights, hatch release switch and/or mechanism. If not using an existing factory grommet, drill a 11/16 inch hole at the selected location. Coat edge of hole with rust preventative. Route the camera cable connector through the hole and insert grommet into hole.

6. The camera cable to the extension cable connect as described below:

A. Yellow RCA- connect to Video (Camera Yellow RCA)

B. White RCA- connect to audio (Camera White RCA)

C. Camera red wire- connect to reverse lamp 12V voltage

D. Camera black wire- connect to chassis ground

7. The extension cable other head connected to the monitor. Yellow RCA connected to the Video input,White RCA connected to the Audio input