Operating Instructions for Prestige APS785 Remote Start System
|
Arming the System - Active: |
- Turn off the ignition, exit the vehicle, and close all doors, hood lid and trunk lid.
- Press and release the Arm/Disarm button on the key chain transmitter one time.
|
Silent Arming - Active: |
- Turn off the engine, exit the vehicle and close all doors.
- Press and hold the Arm/Disarm button for two seconds.
|
Arming the System - Passive (Automatic): |
- Turn off the engine, exit the vehicle, and close all doors.
- The LED begins to flash rapidly, indicating 30 second passive arming has begun.
- Opening any protected entry point during the 30 second passive arming cycle will immediately suspend automatic arming and the 30 second passive arming cycle will restart when all doors are closed. At the end of the passive arming cycle the led will flash slowly, the parking lights will flash once and the siren will sound one chirp.
|
Protection While the System is Armed: |
- Opening any protected door, hood, or trunk lid will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed and ignore that triggered zone.
- Whenever the system is armed, the dash mounted LED will slowly flash. This serves as a visual deterrent to a potential thief. This LED is a very low current light emitting diode and will not drain the battery even if left unattended for long periods of time.
- Whenever the system is triggered, the vehicle's parking lights will flash for the full 30 second alarm cycle, attracting visual attention to the vehicle.
- Any strong impact to the vehicle's glass will cause the alarm to trigger for the full 30 second alarm cycle.
- Any mild impact to the vehicle's glass will cause the alarm to sound a short series of warning tones.
|
Disarming the System: |
- As you approach the vehicle, press and release the Arm/Disarm button on the key chain transmitter.
|
Silent Disarming: |
- As you approach the vehicle, press and hold the Arm/Disarm button on the transmitter for two seconds.
|
While the System is Sounding: |
If during a triggered state, you wish to shut off the siren without disarming your security system, simply press and release any transmitter button other than the disarm button. This action will turn off the siren yet leave the vehicle fully armed and protected. |
Intrusion Warning Signals: |
This system will inform you if an intrusion attempt has occurred while you were away from the vehicle. Upon disarm, the siren will chirp 4 times and the parking lights will flash 3 times. Enter the vehicle and before turning on the ignition switch, observe the LED flash pattern.
- If the LED is flashing one time...pause...one time...pause, etc. then an intrusion attempt was made by impact or a strong vibration that the shock sensor detected. Check the vehicle for possible damage to the glass or body panels.
- If the LED is flashing two times...pause...two times...pause, etc. then an intrusion attempt was made to the hood, trunk or by an accessory triggering device. Check the vehicle for indications of forced entry to these openings.
- If the LED is flashing three ti
|
Comments
0 comments
Article is closed for comments.