Operating Instructions for AA940 Remote Alarm System

Operating Instructions for AA940 Remote Alarm System
Code Learning:	In case the transmitter is lost or you require additional transmitters, the code of the transmitter must be programmed into the receiver before it is capable of responding to the new or additional transmitters. Please perform the following procedure:  With the system disarmed, turn the ignition switch on then off 8 times, ending with the key on, after 4 seconds, the siren will emit 3 chirps indicating the unit is ready to accept programming of up to 3 transmitters. Within 8 seconds, press any button of the transmitter to be programmed. Note: If no transmitter button is activated or the ignition switch is turned off, the unit will exit the program mode. Also, any time the program mode is entered and any transmitter is activated, all other transmitters will be erased. During the program sequence, you must have all transmitters present to be programmed that you wish to operate and activated one at a time during the program sequence. Each transmitter activated will cause the siren to chirp, once for the first, twice for the second, and three times for the third. If a fourth is attempted to be programmed, the first will be erased and the fourth will move the other two forward in the program.
Arming the System:	With the system disarmed, press the arm/disarm button once. The siren will chirp once, the LED will begin to flash and the engine starter will be disabled. 5 seconds after the chirp, the system will be completely armed. During the armed mode, the unit can be triggered by shock/vibration, or a change in voltage such as the interior light turning on.
Arming with Two Stage Shock Sensor Bypassed:	With the system disarmed, press the arm/disarm button once, the siren will chirp once. Within 5 seconds, press button 2 one time. The siren will emit one short chirp indicating the system is set and will be fully armed in 5 seconds with the shock sensor bypassed for one arming cycle. In this mode, the system cannot be triggered by the shock sensor. The only means of triggering is the voltage drop sensor.
Arming with the Voltage Sensor Bypassed:	With the system disarmed, press the arm/disarm button once, the siren will chirp once. Within 5 seconds, press button 2 two times. The siren will emit one long chirp indicating the system is set and will be fully armed in 5 seconds with the voltage sensor bypassed. In this mode, the system cannot be triggered by a change in voltage. The only means of triggering is the shock sensor.
In the Triggered Mode:	When the system is armed, if the voltage drops, or a strong vibration is presented to the protected vehicle, the unit will trigger. If a lesser vibration is presented to the vehicle, the shock sensor will emit a few warn away chirps. When triggered, the siren will sound for 30 seconds then reset and continue to protect your vehicle. During the triggered mode, the unit can be reset by disarming with the transmitter or by use of the override method.
Disarming the System:	With the system armed, press the arm/disarm button once, the siren will chirp two times indicating the system is disarmed. The LED will turn off and the starter disable relay will be enabled allowing the vehicle to start. If the siren chirps four tim