Operating Instructions for AA939 Remote Alarm System |
|
Arming the System: |
Note: Pressing the arming button twice within 3 seconds will allow the unit to arm without the shock sensor. This will be indicated by a single chirp tone followed by a lower single chirp tone. When operating in this mode, the only detection means will be the voltage sensor. The next normal arming of your system will re-instate the shock sensor. |
Protection While the System is Armed: |
|
Disarming the System: |
Note: If you head four chirp tones upon disarm and the parking lights flash three times, this indicates that the system had been triggered in your absence. Carefully inspect your vehicle for break in or physical damage. If you system fails to operate as above:
|
Testing the Voltage Sensor: |
If the unit fails to operate review the following section concerning voltage sensor adjustment. |
Voltage Sensor Adjustment: |
In most instances, connecting the Red siren wire to the vehicle battery will provide adequate voltage sensing. If your vehicle does not trigger when the door is opened and the interior light turns on, it may be necessary to increase the voltage sensor's level of detection. Before making this |
Comments
0 comments
Article is closed for comments.