| Arming the System: (Active) |
- Turn the ignition key off, exit the vehicle, and close all doors.
- Press and release the Lock button on the key chain transmitter.
- The siren and/or horn will beep one time, the parking lamps will flash one time, and the red dash mounted LED will begin to slowly flash, indicating that the system is ARMED.
If the siren/horn sounds 3 chirps, then you have left a door, trunk, or hood lid ajar. Simply close the opened entry point to provide full protection. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected an open entry point after the learned delay expired. Again, closing the hood, trunk, or doors will correct the problem and you do not need to disarm the system to make the correction. If the siren/horn did not sound when arming, then the chirps have been turned off, and you should refer to the section below titled "Eliminating the Arm/Disarm Chirps".
- Any time the door lock switch in the vehicle is used to lock the doors while the ignition key is turned off, the system will immediately arm. To lock the doors after entering the vehicle, make sure the ignition key is switched on first. Turning the ignition key on first will stop the system from arming.
|
| Arming the System: (Passive) |
- Turn the ignition key off, exit the vehicle, and close all doors.
- The dash mounted LED will begin to flash rapidly, indicating that the system is automatically (passively) arming. As an added convenience, the 30 second automatic passive arming will not begin until all doors are closed, allowing passengers to exit the vehicle at their convenience.
- In 30 seconds, you will hear a single short chirp from the siren, and the vehicle's parking lamps will flash one time, indicating that the system has ARMED. At this time, the red dash mounted LED will begin to flash slowly, providing a visual indication that the system is fully armed.
- It is possible to program the system, that when the alarm is allowed to automatically passive arm, there will be a 15 second delay after a door is opened before the alarm will sound. However, if the system is programmed for instant trigger there will no delay. Check with your installer for the setting of this feature.
IMPORTANT: When the system is programmed for passive arming, the system will always arm, even when the key chain transmitter has not been used to lock the doors.
When you leave the vehicle, and a door has been left opened, the system will arm after 10 minutes. If you plan to vacuum the car, or if service work is being performed, either leave the key in the ignition and switched to the on position, or put the system into valet mode. If you do not do this, the system will arm in 10 minutes, and you will probably inadvertently trip the alarm.
|
| Protection while the system is armed: |
- Opening any door, hood, or trunk will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and automatically re-arm the vehicle. If the potential thief left a door opened, the alarm will sound for five more 30 second cycles, then re-arm and ignore the opened door zone.
- Whenever the system is armed, the red dash mounted LED indicator will slowly flash. This serves as a visual deterrent to the potential
|
Comments
0 comments
Article is closed for comments.