Connecting LF-30S Receiver to Components

Connecting the LF-30S Receiver

Connecting the Receiver to a TV or Other Component:

After connecting the transmitter to your A/V source, you must connect the receiver to a TV or another component.

There are two ways to connect the LF-30S Receiver to a remote TV (a TV in a remote location away from the A/V source):

• Connected directly to the remote TV
• Connected directly to a VCR, which is then connected to the TV

Note: If your TV has picture-in-picture (PIP) capability, you can also view any image sent by the transmitter (such as a sleeping baby monitored by your camcorder) in the small inset picture while enjoying other programming on the rest of the screen,. Consult your TV owner's manual for instructions on using its PIP feature.

1. Make sure the receiver's On/Off Switch is "Off".
2. Connect one set of red, white and yellow A/V cables from the A/V jacks for a mono TV), connect one end of an A/V cable to the TV's A/V jacks and the end of the cable to the receiver. Be sure the red, white and yellow plugs on the A/V cables match the red, white and yellow jacks on both the receiver and the TV. If your TV has only one input for audio (mono sound only), connect the white plugs on the cable to that single audio input and the receiver's AUDIO LEFT jack. If your TV does not have A/V jacks, use a coaxial cable to connect the RF output jack of the receiver to the coaxial input of the TV.
   Note: If you already have an antenna or cable connected to your TV, use an A/B switch or modulator (not included) and additional coaxial cables to connect the receiver.
3. Plug the small end of the power adapter into the back of the receiver and the other end into a standard A/C wall outlet. Turn the On/Off switch to the "On" position.
4. Make sure the receiver and transmitter units are set to the same channel.
5. Locate and orient the transmitter unit according to the "Orienting the Transmitter and Receiver Units" FAQ.

Connecting the Receiver to Powered Computer Speakers:

Since the LF-30S only receives stereo audio signals and does not amplify them; the speakers you use to listen to wireless sound must be self-powered or attached to an amplifier or stereo receiver.

1. Make sure the receiver's On/Off switch is "Off".
2. Connect the speaker input cable from your powered speakers to a "Y" adapter mini phone jack adapter (3.5mm to stereo RCA plug - not included).
3. Connect the red and white plugs of the "Y" adapter to the red and white audio jacks of the receiver.
4. Plug the small end of the power adapter into the back of the receiver and the other end into a standard A/C wall outlet. Turn the On/Off switch to the "On" position.
5. Make sure the receiver and transmitter units are set to the same channel.
6. Locate and orient the transmitter unit according to the "Orienting the Transmitter and Receiver Units" FAQ.

Can the Terk Leapfrog LF-30S video connections be u