Why will my disc not play on the AVD400T DVD Player? |
- Insert a disc with the label side facing up.
- Check the type of disc you put into disc tray. This player only plays DVDs, audio CDs, JPEG CD-Rs and MP3s.
- Both the unit and the disc are coded by region. If the regional codes don't match, the disc can't be played.
(NOTE: This DVD player is set to Region Number 1)
|
Why did the AVD400T DVD Player suddenly stop? |
- Turn the player OFF and then back ON.
- If the player still does not respond, press the reset button.
|
Why will my AVD400T DVD Player not turn on? |
- Insert the key into the ignition and turn it to the Accessory position.
- Verify the Red (+) 12 VDC wire is properly connected.
- Verify Black (-) wire is properly connected to the vehicle ground.
- If the player is still not working, then condensation may have formed in the DVD player, please allow the player time to dry out (about half an hour).
|
Why is my remote not working to my AVD400T DVD Player?
|
- Verify that the batteries in the remote are fresh.
- Verify that the remote sensor eye is not obstructed.
|
Why is there no sound or distorted sound coming from my AVD400T DVD Player? |
- Make sure your unit is connected properly.
- Make sure all cables are securely
inserted into the appropriate jacks.
- If you are using the 2-channel IR headphones, make sure you turn on the IR headphone power, make sure the correct channel (A-B) is selected.
- Make sure the Modulator is ON and the proper Frequency has been selected on
the DVD player.
|
Why does play start, but then stops immediately on my AVD400T DVD Player? |
- Be sure the disc is clean before inserting it in the DVD Player.
- If condensation has formed in the DVD Player, allow the player time to dry out.
|
Why is there no sound is being produced from the IR headphones that are connected to my AVD400T DVD Player?
|
- Verify that the headphones are turned on.
- Consider replacing the batteries to the headphones if they are old or weak.
- Verify that the volume is turned up if you are using wired headphones.
|
Why can I not fast forward or reverse scan on my AVD400T DVD Player? |
- Some discs have sections that prohibit rapid scanning or title and chapter skip.
- If you try to skip through the warning information and credits at the beginning of a movie, you won't be able to. This part of the movie is often programmed to prohibit this action.
|
What does the "not allowed at the moment" icon mean that appears on the screen of my AVD400T DVD Player?
|
The feature or action may not be completed at this time because of one of the following reasons:
- The disc's software restricts it
- The disc's software doesn't support the feature (i.e. angles)
- The feature is not available at the moment
- You have requested a title or chapter number that is out of range
|
Why do I hear static or have poor sound quality on my AVD400T DVD Player?
|
In certain areas where there are a large number of FM radio stations (i.e. large cities, urban areas), the reception of the FM signal from the overhead pod may not be satisfactory, resulting in static, distorted sound or signal bleed through from strong local radio stations. This is not a defect in the product, but the result of a stronger local radio station overpowering the wireless FM transmitter in your overhead pod. |
Comments
0 comments
Article is closed for comments.